Skip to main content

Translate

Browse by Topic

Featured

The Temple That Was Nearly Dismantled for a River Weir

In 1836, granite from the Chola temple complex was removed for construction of the Lower Coleroon Anicut. In 1836, work began on the Lower Coleroon Anicut across the Kollidam River in Tamil Nadu. The project needed large quantities of stone. Nearby stood an 800-year-old Chola temple built largely from granite. It became a quarry. A Capital Built in Stone The Brihadisvara Temple at Gangaikondacholapuram was built by Rajendra Chola I as the centrepiece of his new imperial capital. Completed in 1035, its 53-metre vimana rises in a graceful curve, noticeably different from the straighter and more severe tower built by Rajendra’s father at Thanjavur. ( UNESCO World Heritage Centre ) Completed under Rajendra Chola I in 1035, the temple’s 53-metre vimana remains the dominant surviving feature of the former Chola capital. Eight centuries later, that carefully worked granite attracted attention for a very different reason. It could be reused. What the Historical Record ...
Post a Comment
Read more
Labels

Part 6 — Wall Sections & Details | Sheet by Sheet

 

Every builder has a story about a detail nobody read until it was too late.

Wall sections and details are the most technical sheets in any residential set. They're also the ones contractors reach for most on site — when something doesn't fit, when a material transition isn't clear, when a connection needs verification.

What it shows:

  • Full wall assembly from foundation to roof
  • Exterior cladding, sheathing, framing, insulation, interior finish
  • Waterproofing and moisture barrier locations
  • Window and door head, sill, and jamb conditions
  • Floor to wall connections
  • Roof to wall connections and eave details
  • Flashing locations and types

Why details matter:

A wall section tells the contractor how the wall is built. A window jamb detail tells them exactly how the window sits in the opening — setback, flashing, sill slope, interior trim clearance.

Without the detail, the contractor makes a judgment call. Sometimes that's fine. Sometimes it leads to a water infiltration problem three years after handover.

Where builders get burned:

Generic details copied from a previous project without checking against current conditions. A detail drawn for a 2x4 wall applied to a 2x6 wall. A flashing detail that doesn't match the specified window product. Details need to be project-specific — not just plausible.

Email Post
Labels:

Comments

Post a Comment

Did you enjoy this post?

Popular Posts